Adjustable Hydra Stamp

What It Supports

• ✔ Delivers serum directly through the needle head while stamping — one step instead of two
• ✔ Creates micro-channels that support absorption of the serum applied during and after use
• ✔ Supports the appearance of smoother skin texture and more even tone with consistent use
• ✔ May help support the look of firmer, more hydrated skin over time
• ✔ Supports the appearance of a healthy scalp environment when used with scalp oils or serums
• ✔ Adjustable depth from 0.25–1.5mm — gentle surface work at 0.25mm up to deeper scalp sessions at 1.5mm
• ✔ 10ml glass chamber is refillable and easy to clean — use with any compatible water-based serum

*Individual results may vary.

What You'll Get

• 1 × Adjustable Hydra Stamp — includes 24 stainless steel needles (0.25–1.5mm adjustable depth), 10ml refillable glass serum chamber with pull-off top, and protective cap

Specification

Needle Count: 24

Needle Material: Stainless steel

Depth Range: 0.25mm – 1.5mm (fully adjustable)

Depth Mechanism: Manual twist dial

Serum Chamber: 10ml refillable glass

Chamber Top: Pull-off for easy filling and cleaning

Use Areas: Face, neck, scalp, targeted areas

Compatible Serums: Water-based, fragrance-free (e.g. hyaluronic acid, like our Hyah Serum)

Power: None required — fully manual

Recommended Replacement: Every 6–10 uses, or sooner if needles appear dull or bent

Before Use

1. Start with clean, dry skin or scalp.
2. Dip the needle head in rubbing alcohol for 60 seconds. Air-dry fully before use.
3. Pull off the top of the glass chamber and fill with
   your chosen serum. A water-based, fragrance-free serum like hyaluronic acid works best. Replace the top.
4. Set your depth using the twist dial. Start at 0.25mm for the face if you are new to the tool.

 During Use

1. Press the stamp gently onto skin and lift — do not drag or roll. Work in small sections, covering each area 2–3 times with light, even pressure.
2. The serum flows through the needle head on contact with
   the skin. For more consistent coverage, you can apply a thin layer of serum to the skin first, then stamp over it — this is a common technique and not a product defect.
3. Avoid broken skin, active breakouts, or open wounds.

After Use

1. Apply any remaining serum or a soothing moisturizer to the treated area.
2. Pull off the chamber top. Rinse the chamber and needle head with warm water, then dip the needle head in rubbing alcohol for 60
   seconds. Air-dry fully before storing.

Frequency by Depth

• 0.25–0.5mm — Up to 2–3 times per week. Minimal
  downtime.
• 0.5–1.0mm — Once per week. Mild redness is normal;
  fades within a few hours.
• 1.0–1.5mm — Once per week. For scalp use. Allow 5–7
  days between sessions on the same area.

Before You Use

⚠️ Only use serums specifically formulated for microneedling or listed as safe for post-needling use. Avoid vitamin C, retinol, AHAs, BHAs, or alcohol-based products in the chamber or immediately after use.

⚠️ Patch test any new serum on the inner wrist for 24 hours before using in the chamber.

Do not use if you have:

• Active breakouts, open wounds, or skin infections in the treatment area
• Eczema, rosacea, or psoriasis flare-up in the treatment area
• A history of keloid scarring
• Blood-thinning medication
• Pregnancy or nursing
• Under 18 years of age

 Keep out of reach of children.

If you have a skin or scalp condition or are under medical care, consult your healthcare provider before use.

Who It's For

A good fit for anyone who wants to combine microneedling and serum application in a single step. The built-in glass chamber means you’re not reaching for a separate bottle after each session — the serum is already loaded and delivered as you stamp. The 0.25-1.5mm depth range covers everything from gentle daily facial use to targeted weekly scalp sessions.

If you prefer to keep your microneedling tool and serum separate — or want to use thicker oils like castor oil with rosemary that won’t flow through the chamber — the Adjustable Derma Stamp is a
better match.

What to Expect

With consistent weekly use, most people notice changes in skin texture and hydration within a few weeks. The built-in serum delivery means your skin is receiving the product exactly where micro-channels are open — immediately after needling is when topical products are commonly applied as part of a microneedling routine. For scalp routines, allow 8–12 weeks before evaluating results.

Results depend on the serum used, the depth setting, and how consistently the routine is maintained.

*Individual results may vary.

This product is intended for cosmetic use only and is not intended to diagnose, treat, cure, or prevent any disease or medical condition. Not a substitute for professional medical advice.

Common Questions

Q: How does the serum come out of the stamp?

A: The serum flows through the needle head on contact with the skin — the pressure of stamping draws it through. Flow rate depends on the viscosity of the serum: thin, water-based serums like hyaluronic acid flow most easily. If you want more consistent coverage, try applying a thin layer of serum to your skin first, then stamping over it. This is a widely used technique and gives reliable results with any serum weight.

Q: What serums can I use in the chamber?

A: Use water-based, fragrance-free serums. Hyaluronic acid serums work well — including the Beautimate Hyah Serum. Do not use oil-based products, thick balms, or serums containing vitamin C, retinol, AHAs, or BHAs in the chamber. Those ingredients are too active for
direct delivery into micro-channels and can cause irritation.

Q: How do I fill and clean the chamber?

A: Pull off the top of the glass chamber. Use a dropper or pipette to fill with your chosen serum. Replace the top firmly before use. After each session, pull off the top again, rinse with warm water, and dip the needle head in rubbing alcohol for 60 seconds. Air-dry fully before storing.

Q: What depth should I start at?

A: Start at 0.25mm for the face if you are new to microneedling. This is comfortable for most skin types and allows you to get used to the stamping motion. Once you’ve used the tool 2–3 times and your skin is comfortable, you can move to 0.5mm. For scalp use, 0.5–1.0mm is typical.

Q: How is this different from a regular derma stamp?

A: A regular derma stamp has no serum chamber — you stamp first, then apply serum separately. The Hydra Stamp delivers the serum through the needle head as you stamp, so you’re applying it at the moment micro-channels are open. The trade-off is that only thin,
water-based serums work in the chamber. For oils or thicker actives, a standard derma stamp is a better fit.

Q: Can I use oils in the Hydra Stamp?

A: No. Oils such as castor oil and rosemary oil are generally too thick to flow reliably through the chamber. Apply them directly to the skin or scalp before or after stamping instead.

Q: How often should I use it?

A: Depends on depth. At 0.25–0.5mm, up to 2–3 times per week. At 0.5–1.0mm, once per week. At 1.0–1.5mm, once per week with 5–7 days between sessions on the same area.

Q: Can I use it on my scalp?

A: Yes. The Hydra Stamp works well on the scalp, especially when loaded with a lightweight scalp serum. For oil-based scalp treatments like rosemary or castor oil, the standard technique of applying the oil to the scalp first and stamping over it is recommended —oils are too thick to flow reliably through the chamber.

Q: When should I replace the needle head?

A: Every 6–10 uses. Replace sooner
if needles feel less sharp, snag on skin, or appear bent when inspected.

Q: What is your return policy?

A: We offer a 30-day money-back guarantee. If you’re not satisfied for any reason, contact us and we’ll arrange the return.